Walco Power Solutions is an energy savings company staffed with personnel with over ten years of experience in the field of energy saving systems.

In today's harsh economic environment costs are escalating in excess of 12% annually. The price of goods and mast moving consumables are on the increase and even double in price every 5 years. The bad news is that people’s salaries only increase by say 7% per annum, if they are lucky. The cause effect = people are actually getting poorer.

Walco Power Solution saw the opportunity to assist people in saving costs on energy use thereby allowing them to better their monthly cash-flow.

Geyser Master :
Walco Power Solutions will install the Geyser Master device next to your distribution board and is programmed to switch off your geyser when hot water is not required in large amounts. It is not the same as a timer because it detects current and not time. Unlike a timer, the device will wait until you have finished using hot water, then it will allow the water in the geyser to reach its maximum temperature again before regulating the flow of current.

This means that you will have sufficient hot water to wash dishes or hands, etc. until the device automatically switches the geyser back on in time for your next shower or bath. The Geyser Master is multi programmable with 8 daily times so you can set it to turn your geyser on when you want.

Geyser Blanket :
We further wrap your geyser in a temperature control blanket to further increase the efficiency of keeping the water temperature inside the geyser stable. The geyser blanket is a very effective cost saving device. This insulation device prevents heat from escaping through the geyser and thus keeps water warmer for longer.

Power Buddy :
As an added value we install the Walco Power Buddy energy saver that uses a combination of filtration and correction techniques to improve the efficiency of various appliances and circuits. In addition, the intelligent technology optimizes the voltage and current demands thus reducing the active power/KWH demands and achieves around 10-20% saving on your electricity bill.

It also acts as a voltage stabilizer by storing energy for up to 10 seconds and therefore supplies load with proper voltage during momentary power surges.

The typical loads include the following: 

• Fridges
• Pool Pumps
• Freezers
• Air conditioners
• Washing Machines
• Low Voltage Lighting
• Tumble Dryers
• Fluorescent Lighting
• Dish Washers
• Vacuum Cleaners etc.

By reducing the over-current on Inductive loads the Power Saver reduces the amount of Heat Exchange in the Wiring. The benefit of this is that the amount of Oxidation is reduced and due to heat exchange reduction, the cable life and appliance lifespan is prolonged.

R 17 100.00 - There are no royalties

Included - 4 days

To be discussed with franchisor